衰减曲线分析的诺模图

基于Arps递减方程,建立了衰减曲线分析的诺模图。应用该诺模图,可以方便地确定油气田的可采储量。     

EC与~（99m）Tc－GH之间的配体交换反应动力学研究

实验表明，ＥＣ浓度与配体交换反应速度常数无关，体系的ｐＨ值对速度常数和９９ｍＴｃ－ＥＣ的标记率影响较大。测定并计算了不同ｐＨ值的交换反应速度常数。结果表明，为保证用配体交换法制备９９ｍｃ－ＥＣ时９９ｍｃ－ＥＣ的标记率大于９０％，体系的ｐＨ值必须≥８。     

阿姆河流域耕地变化及水土匹配特征分析

基于中亚阿姆河流域4个分区1990—2015年间土地利用变化和水资源等数据,运用耕地变化速率、洛伦兹曲线和基尼系数法以及水土资源匹配系数对阿姆河流域耕地变化和水土匹配状况进行了综合分析。结果表明:1990—2015年阿姆河流域耕地以146.74 km²/a的速度在扩张,且各时期、各分区扩张的速度不同;在不考虑咸海来水不断减少、生态持续恶化的前提下,绿洲区匹配状况属比较公平和相对合理状况;阿姆河流域水土资源空间分布存在明显的错位现象;全流域生态用水被农业用水严重挤占,阿姆河流域灌溉面积、灌溉用水量成为影响咸海水量及面积变化的重要因素,是一种不可持续的用水方式。     

A relation between interfacial and bulk properties along the saturation curve

A liquid-vapor interface in thermal equilibrium was considered, where the pressure tensor depends upon the density (z) and the position z. The surface tension coefficient results are parametrized with the bulk compressibility, liquid-vapor density difference, and interfacial width along the saturation curve. Previous results at the triple and critical points reported by other investigators are verified. Also included is a plot of the computed results using the parametric equation and experimental data for different substances.     

Oxidative dimerisation of propene to 1,5-hexadiene on Bi-Zn-O catalysts

The oxidative dimerisation of propene to 1,5-hexadiene has been investigated on Bi-Zn-O catalysts. The Bi₄₈ZnO₇₃ phase, observed in the catalysts calcined at 700 ° C is an active and selective catalyst for the formation of 1,5-hexadiene. The best catalytic performance (1,5-hexadiene selectivity 64%) has been obtained at 525 ° C, with a propene to oxygen ratio of 26, on a catalyst formed by Bi₄₈ZnO₇₃ with a small excess of ZnO.     

非致命打击武器系统内弹道模拟研究

为了实现对非致命防暴武器发射能量的调节并控制其终点效能,解决"近处不敢打,远处打不到"的问题,提出了恒量动能非致命打击武器系统这一全新理论,在选用了两相流内弹道模型的基础上,采用四阶龙格库塔法,利用MATLAB语言仿真技术进行编程测试,对改进型18.4mm防暴枪的内弹道进行数值仿真,并将模拟结果与实验结果进行分析比对,验证了内弹道模型和仿真结果的正确性,得到了发射过程中,膛内火药燃烧及燃气流动状态的变化规律,弄清了泄气孔位置、气室容积以及泄气孔半径对弹丸初速的影响规律,为非致命防暴武器的进一步发展打下了坚实的基础。     

双参数Bézier曲线的升二次扩展

本文以二次Bernstein基函数为例,首次提出了含双参数基函数的新扩展——αβQ—Bern-stein基函数,此类基函数具有新的特点,即基函数的扩展次数一次性升高两次,且包含了二次多项式和带一个参数的三次多项式基函数的所有性质。基于这组基函数定义了αβQ—Bézier曲线,该曲线也含有参数,具有形状可调性,当α与β取某些值时曲线能达到C4连续或在某个端点处C0连续。最后与含两个参数的升一次Bézier曲线进行比较,该曲线具有调节范围广、灵活性更强的优势。     

Stannate and permanganate conversion coatings on AZ31 magnesium alloy

The formation of stannate and permanganate–phosphate conversion coatings on AZ31 magnesium alloy was investigated in situ by EIS measurements and their protective performances were studied by different electrochemical techniques in diluted (0.05 M) sodium sulphate solution.The influence that short or long treatment times exert on the performances of such conversion coatings is discussed. While permanganate–phosphate baths always built layers characterized by penetrating cracks, long stannate baths produced layers without interconnected porosity, but were defective. This accounted for the initial greater protectiveness achieved with the stannate treatment; nevertheless, the easy penetration of the electrolytic solution through such a layer quickly decreased its corrosion resistance.     

步进电机S曲线精确控制的研究与验证

针对生产中对步进电机运行时间和距离有精确要求的常见工况,设计一套步进电机S曲线控制算法,根据不同的运行要求灵活设定运动过程,设定较少参数即能规划整个运动路径,达到理想的运动效果。设计新型余弦S曲线,搭建MATLAB/Simulink仿真控制模型和硬件测试系统进行仿真和试验验证。结果显示电机实际加减速过程运行平滑,起步稳定振动小,设定参数下可以精确运行,与直接起停相比,运行效果有很大改善。新型余弦S曲线已在全自动号码机项目中得到实际应用。     

等误差直线逼近非圆曲线节点计算新方法

传统的等误差直线逼近法从被逼曲线的端点开始计算节点.文章在此基础上提出一种非圆曲线节点计算新方法,以被逼曲线曲率半径最小点开始,按等误差法求取节点,再根据曲线规律对节点重新进行排序,输出节点坐标值.用该种方法逼近曲线,在逼近误差等于等误差法逼近误差的条件下,节点数少于等误差法求得的节点数,文中用C语言编写新方法求取节点程序,并与传统方法进行比较,最后用曲线方程进行验证,结论正确,具有实际意义.